To change area attributes
main topic      example 

1    Double-click any contour area.

2    Under Fill Color, choose one of the following:

·    Spectrum to represent the contour areas using a spectrum.

·    One-color ramp to represent the contour areas using one color. (Only available if the contour plot has less than six levels. If you reduce the number of levels to be less than six in the Options tab, you must click OK before Minitab enables the Attributes tab.)

-    From Color, choose a color to represent the z-values.

·    Two-color ramp to represent the contour areas using two different colors.

-    From Low-end Color, choose a color to represent the lower z-values.

-    From High-end Color, choose a color to represent the higher z-values.

·    Custom colors to select colors individually for each of the contour areas.

-    Under Color, choose a color for each contour area. Row 1 is for the lowest z-values.

-    Under Fill Type, choose a fill type for each contour area. Row 1 is for the lowest z-values.

4    Click OK.