1 Double-click the area. See Selecting
groups and single items.
2 Click
the Options tab.
3 Under
Projection Direction,
choose one of the following:
· Toward Y scale
to extend areas horizontally
towards the y-axis.
· Toward X scale to extend
areas vertically
towards the x-axis.
4 Under
Connection Function,
choose one of the following:
· Straight to connect
points with straight lines,
then fill the area underneath.
· Step to connect points
using a step pattern.
Choose Left to
make steps with each point at the left of a step level, Center
to put each point in the middle of the step level (the default), or Right to put each point
to the right of the step level.
5 Under
Base Position,
choose one of the following:
· Auto
to use the default base,
which is the minimum data value for the y-scale.
· Custom
to define your own base, then enter a number for the base. Areas extend
from the data value to the base.
|
Tip |
You can add a horizontal or vertical base line by adding
a reference line
that has the same data value as your base. |
6 Click
OK.
To change the area options